Joshua-
This post is pretty ancient and I'm sure that you have long resolved this issue, but I was trying to remember who we used to re-corrugate our Roskamp rollers back in 2020. I drove those up to Waterloo, IA to Roskamp Champion (CMS). Apparently Waterloo must be a hotbed of mill fabrication, because I saw a number of other options for re-corrugation and sharpening. Here's one you might check out for the Engl: https://www.schererinc.com/corrugated-metal-roll/
------------------------------
Geoff Deman
Professor; Post Doctorate; Graduate Student; Student
Free State Brewing Co
Lawrence KS
(785) 843-4555
------------------------------
Original Message:
Sent: 05-15-2025 14:21
From: Joshua Maxson
Subject: Sharpening Rollers from an Engl Mill
We've had an Engl mill for about 12 years now. A few years ago we replaced it as our main service mill with an RMS 4 roller, but we've kept it inline and use it to crush a few specialty grains and as a back up in case anything happens to our RMS. We have never pulled and sharpened the rollers on our Engl throughout its life and during some recent maintenance realized they are pretty dull. (Duh right?).
We have reached out to the manufacturer but they haven't been very responsive or helpful sadly, and finding a part supplier for replacement rollers or finding a machine shop locally who can sharpening our existing rollers has been a challenge. I was wondering if anyone else with one of these has solved this problem in the past and has some advice on how to get our rollers back up to snuff.
------------------------------
Joshua Maxson
Confluence Brewing Company
Des Moines IA
(319) 400-9678
------------------------------